Lombax Original
Lumbar Support Belt
Features & benefits
The reference belt for occasional use
- Strong compression elastic fabric.
- Lumbar reinforcement with 4 stays. (1)
- Abdominal reinforcement with 2 stays. (2)
- Two-part front fastening system with finger loops (3)
- Easier to hold and fasten due to several hand loops. (4)
- Improved comfort due to 3D knit
Suitable for intermittent wear
Indications
- Initial support of acute or chronic lumbar pain and sciatica.
- Prevention of lumbar pain (strain, incorrect posture).
- Post-operative lumbar support.
Sizing guide
Fitting & user guide
FITTING INSTRUCTIONS
- First, slip your right hand through the lower strap with the label marked "THUASNE".
- Place the belt around your waist (inside label upwards). Hold the belt with your left hand flat against your stomach, without pulling.
- Pull with your right hand (in front of you then towards the left) and fasten the lower strap on the opposite lower part.
- Repeat this operation with the upper strap.
- Check with your hand that the fabric between the two central stays at the back (there are 4 in total at the back) is properly positioned against your spine to make sure the belt is centred as well as possible.
For improved comfort, loosen the upper strap when sitting down.
Care instructions
- Wash only with soapy water, without detergent or bleach.
- Squeeze out excess water.
- Dry away from heat sources